May 9, 2022

Discharge SignI’ve always thought that where safety is concerned aboard, it should be the same whether the boat is a commercial, passenger-carrying vessel or a privately owned sail or power boat. In most cases, safety requirements in terms of construction and safety-gear is comparable, based on vessel size and use – but one of the main differences that has always annoyed me is the requirements for separate water-tight bilge compartments in commercial craft, while that the majority of production sail and power boats don’t require any compartment division.

This means that while  bulkheads in privately-owned boats are structural, they are not necessarily watertight: water will flow from bow to stern (or vice versa), and will collect in the lowest part of the bilge. This also means that if damage occurs anywhere on the boat, the entire boat will fill. In commercial craft, sections are required to be watertight: if damage occurs, only the compartment that is damaged will fill with water, the hope being that despite one compartment flooding, the boat will still stay afloat.

In a commercial boat, each compartment would be required to have it’s own bilge pump to allow any water entering or collecting (through through-hulls, stuffing box, rainwater, seawater or damage) to be pumped out independently. The compartments that are least likely to accumulate water regularly would have bilge pumps operated with a simple on/off switch. A compartment that is more likely to collect water (for instance, where the stuffing box Is located - where the propeller shaft runs through the hull) would have a bilge pump operating on a float switch: as the water level rises, the float engages and turns the pump on. Once the water level drops, so does the float, and the pump stops running. 

In a privately owned boat – either power or sail – the bilge is essentially one large compartment. Water will collect in the lowest part of the bilge, which is usually near the engine. For both safety and convenience, a single bilge pump that operates on a float switch is sufficient and practical.

Here’s where things become a bit complicated: Most boats in Canadian waters (with an inboard engine) are required to have a placard affixed in or near the engine space that states that it is illegal to discharge oil into Canadian waters

In a commercial vessel, it’s relatively easy to comply: before engaging any bilge pump, make sure that the water in that compartment isn’t full of oily water before engaging the pump. Any water-tight compartment that has a bilge pump operating on a float switch will not be connected to areas that are oily or have the potential to pollute (the rule of thumb is that the engine compartment - where oil, fluids, dirt and dust are present – would have a bilge pump that is not operated on a float switch, so that there is no chance of accidental pollution.

Bilge Pump Oily Waternote the bilge pump, sitting in oily water, under the engine

Here’s the baffling part: The bilge pump on a typical privately owned sail or power boat is located near the engine. Any spilled oil, gear lube, power steering fluid, hydraulic oil, coolant or fuel will land in the bilge and head straight for the bilge pump. If water has accumulated, a float activated pump will pump this filthy oily disgusting water overboard, which contravenes the requirement on the placard stating that discharge of oily water is prohibited and can result in hefty fines (let alone the environmental damage that may be caused.

On one hand: the boat is designed to have a bilge with the lowest point at or near the engine. It is practical and safe to have this bilge pump on a float switch so that if water accumulates when no-one is aboard, the boat will be protected from flooding

On the other hand, we have a legal and environmental requirement to not discharge oil overboard.

How do we reconcile the two?


Sheen of Oilthe sheen of oil on the waters surface indicates that perhaps someone has dumped their bilge here

 

1) Whenever performing work on the engine where there is a chance that oil, fluids, fuel or coolant can spill, disconnect the bilge pump to eliminate the chance that it accidently engages until work is complete and the area is cleaned up.

2) Keep the bilge clean – keep oil, dirt, detritus to a minimum, and give the bilge area regular cleans with an appropriate cleaner

3) If concerned about leaks or pollution from the engine, consider installing a pan below the engine to collect any spills before they hit the bilge

4) Take advantage of modern components and solutions, such as dripless stuffing boxes, which can drastically reduce the amount of water the enters the boat
5) Keep bellows, through-hulls and seacocks well maintained. The less water entering the boat, means fewer cycles of the bilge pump moving water overboard, reducing the chance of accidental pollution

6) Before moving bilge pumps, or making compartments water-tight, consult with a qualified marine tech who can advise you on the pros and cons of making changes that can impact safety and stability.

Andrew McDonaldAndrew McDonald is the owner of Lakeside Marine Services – a boat repair/maintenance firm based in Toronto. Andrew has worked in the marine industry for 12 years and is a graduate of the Georgian College ‘Mechanical Techniques - Marine Engine Mechanic’ program.

Questions or comments for Andrew? Email him directly via: This email address is being protected from spambots. You need JavaScript enabled to view it.

 

Related Articles

Wednesday, 09 August 2017 02:52

The moment we all dread. It’s a warm sunny day and you’re out for a cruise. Suddenly the boat shudders beneath you, pings, dings and clangs are heard and you realize that you’ve hit something...

Monday, 28 January 2013 09:46

When it comes to making environmentally friendly choices, the tradeoff is not always paying more for something that doesn't work as well. Boat owners seeking a "greener" sacrificial anode have an...

Wednesday, 10 May 2017 00:43

Question: Can I buy generic automotive parts or products for my boat, or should they specify ‘marine’?

Monday, 24 March 2014 15:51

Understanding how systems really work – and degrade over the winter – can help you prepare your boat for a trouble-free season. Here’s a guide from a pro…Sometimes the most daunting thing about...

Tuesday, 11 July 2017 07:16

For most of us – this is the time to make the most of the boating season – launch and set up are done. Systems have been recommissioned. Let the fun begin!

Saturday, 09 July 2016 21:10

One of the largest, if not the largest,boatyard in Nova Scotia is South Shore Marine. Located around the corner from village of Chester, the yard, which began in the late 70s, now hauls about 500...

Boat Reviews

  • Prev
When we arranged to interview the designer and manufacturer to write a profile of the X Shore Eelex ...
Last August, we were again invited to the Neptunus Yachts facility in St. Catharines, Ontario to ...
Cruisers Yachts’ 34 GLS is the latest model in the Cruisers Yachts line that includes a dozen ...
On a beautiful summer morning in July, I hopped aboard a new-owner delivery from the Outer Harbour ...
When company founder Marcio Schaefer designed the Schaefer 303, he managed to really dial in the ...
There is an unmistakable look to the Azimut S6 Coupe that will stand out in almost any marina. The ...
No longer an outlier or a flash-in-the-pan idea, electric boating is fast becoming a viable ...
Sea-Doo’s all-new Switch marries the performance of a personal watercraft with the versatility of a ...

Video Gallery

 

 

X Shore Eelex 8000By Andy Adams

100% Electric performance available now

When we arranged to interview the designer and manufacturer to write a profile of the X Shore Eelex 8000 for the June 2021 issue of Canadian Yachting magazine, it was on the understanding that we always prefer to actually drive and experience the boats we write about, and we were especially keen to drive the X Shore when BCI Marine here in Canada, got their first boat from Sweden.

There has been a lot of media attention around everything electric lately, especially electric vehicles, but so far, most electric boats are a concept, not yet a reality. The X Shore Eelex 8000 is a reality and a very impressive one at that.

Read More

 

 

 

Neptunus 650EBy Andy Adams

Last August, we were again invited to the Neptunus Yachts facility in St. Catharines, Ontario to run and review their latest yacht, a 202650E at their marina by Lake Ontario. Keen readers of Canadian Yachting might recall reading about a Neptunus 650 back in 2016 and while this is the same proven hull, Neptunus is a custom builder and the 2022 650E here has a totally new interior design and layout.

Neptunus builds bespoke yachts. The reality is that no two Neptunus Yachts are the same. Each is individually tailored to its owners tastes and activities and is finished to their specifications. 

Read More

Destinations

  • Prev
Instant towns have sprung up in the past, especially on the BC coast. In the late 1850s, Victoria ...
Following the War of 1812, a battle that Canada narrowly won against the United States, the ...
You’ve weathered COVID and you’re ready to book your charter to paradise. You’ve done some ...
If you are looking for an interesting destination for a weekend trip or longer, Quebec City will ...
A holiday often is defined by the experiences we make in unique and beautiful settings. But what ...
St Vincent and the Grenadines is open to tourists and Horizon Yacht Charters are looking forward to ...

Marianne ScottBy Marianne Scott

Instant towns have sprung up in the past, especially on the BC coast. In the late 1850s, Victoria grew overnight into a tent city when hordes of prospectors stopped by to provision for their quest to get rich in the Fraser goldfields. The tents were followed quickly by brick hotels, stores and brothels. Prince Rupert began as a tent town after it was chosen as the Grand Trunk Pacific Railway’s terminus, then built more permanent structures.

But no place went up overnight like Ladysmith, where coal baron James Dunsmuir moved his miners “stock, lock and barrel” after coal seams further north on Vancouver Island had been exhausted.

Read More

Lifestyle

  • Prev
Ahoy me hearties. June is Sailpast month, so Keelly and her pal Tracey were themed out as (not ...
Things are busy on the Trent already and it’s barely June. Mike Gridley sent us this shot last ...
From cottage boats to luxury cruisers, there have been a host of major design changes over the past ...
Thanks to Louise from Gyles Sails and Marine for catching us up on this weekend’s massive parts ...
The marine industry provides exciting opportunities for Canadians. Every month CYOB will introduce ...
There are two POTWs this time. The reason? Guilt. We are picking up the first one from the internet ...
So, I’m at Mobility Cup in Nepean, across the river from Ottawa. I’ve participated in Mobility Cup ...
Emirates Team New Zealand, who introduced foiling to America’s Cup competition in 2012, is ...
Our own Ask Andrew ‘floated his Fanny down the Ganny’ in the annual boat race held on Ganaraska ...
While there’s all kinds of discussion, particularly in NZ, about the plan to defend the 37th ...

Marine Products

  • Prev
The little darlings can’t wait to get on the boat. Just make sure they have properly fitting PFDs ...
With a bold, fresh look and key features, the new JBL-R4500 is the latest in the WAKE Series of ...
When the twist-type connector was invented in 1938, production boats were made of wood and didn't ...
Luxor Marine & RV products offer boat owners an innovative architecturally pleasing range of ...
The club's first digital guide is the collaborative effort of dozens of CCA members and now ...
The days are lovely and what better way to celebrate than heading to the engine compartment. Here ...
While collapsible bimini tops offer boaters a welcome escape from direct sun, deployment and ...
Volvo Penta is launching its Assisted Docking system as a retrofit upgrade for many yacht owners ...
Don’t let offshore emergencies turn into disasters. SeaKits help to prepare you for emergencies at ...
It’s one of the best things about sailors: we hate to give up on our equipment. But if you’re like ...

News

  • Prev
Hello Lake Ontario Boaters. As you know, the much anticipated PORTS Lake Ontario Guide is in ...
Watching whales and other marine mammals in their natural surroundings is exciting. It gives us an ...
Tom Brady couldn’t have thrown a better spiral. This is a shot of my handsome son, Will, carrying ...
A strong contingent of 28 Canadian sailors, including Tokyo 2020 Olympians Ali ten Hove, Mariah ...
Wellcraft teamed up with American naval architect, Michael Peters, and talented yacht designers, ...
Following success in the Nordics and New Zealand, Skipperi is coming to Toronto with 15 new, fully ...
Candela, the Swedish company that is revolutionizing electric boating with its hydrofoiling ...
Scrub Island Resort, Spa & Marina has announced plans for the addition of a new petrol station ...
SailGP, the international racing series featuring high speed F50 wingsailed catamarans, is ...
First, they were closed - as of May 2, many of the Canada Border Services Small Vessel Reporting ...

RS Electric BoatsSailGP, the international racing series featuring high speed F50 wingsailed catamarans, is partnering with RS Electric Boats – sister brand of sailboat manufacturer RS Sailing – to use the Pulse 63 electric RIB as chase, coach and support boats.

RS Electric Boats will supply SailGP with four Pulse 63s, which were designed to be electric boats from the outset. The unique aerodynamic hull form is designed to support the weight of the batteries while allowing rapid acceleration, functional speeds up to 23 knots and ample range.

 

 

Read More