Dec 14, 2017

Battery Maintenance Opening CoverInserting a screw-driver to remove the maintenance cover

whether you choose power or sail (or both) batteries are an important part of your boat’s electrical system. Batteries provide the power needed to start engines or generators, and to run the electrical appliances onboard while at dock or underway.

Boat builders are getting better and better at making onboard power easy for us and battery manufacturers continuously improve the design and ‘maintenance-free’ aspects of their products. But, I don’t think it’s too far a stretch to think that most of us use the conventional battery – the type that is the least expensive, and lightest to carry.

Battery Maintenance Opening Cover
Cover removed showing the fill holes and lead plates inside.

These batteries – called lead-acid type – are essentially as described: a series of lead plates, immersed in an acid solution. The chemistry gets a bit complicated (and forgive me for oversimplifying this), the liquid solution changes over time, moving in composition between acid and water, depending on the amount and frequency of recharging. When the battery is fully charged, it is more acidic. When the charge is depleted, it is more like water. When the battery is left depleted, over time the water will evaporate, lowering the level of the solution inside the battery.

These types of batteries are designed to be maintained, in two ways:

1) Keeping a charge up, by running a battery charger periodically, as the voltage drops over time

2) Adding distilled water to the battery if the level of solution inside drops below the top of the lead plates inside. The top of these batteries can be removed – a flashlight can be used to see the top of the solution inside – and distilled water added to each hole (carefully, using a funnel). Protective gloves and eyewear should be used during this procedure. Once filled, the battery should be left to slowly charge (also called trickle charging.


Battery maintenance has been talked and written about in many articles and books and many boaters are familiar with these procedures. Butmaintenance is becoming more and more important as electronics become more sophisticated.

AC appliances on boats are run by shore power (or a generator). Without shore power or a generator, the AC appliances don’t work.

However, DC appliances can run anytime and anywhere, as long as there is enough battery power to support them. While underway (away from shore power) batteries support all the lights, electronics, starting power for engines, VHF radio, fridge, pumps, instruments etc. With more and more sophisticated equipment onboard, batteries are being used more frequently, handling bigger loads, being regularly depleted and recharged, requiring maintenance more often.

What many of us forget, though, is that the batteries are still doing all of that work while plugged into shore power at dock. Here’s how that works: If you run your DC fridge at dock all weekend, the batteries are powering that fridge. The shore power is simply providing power to the battery charger to recharge the batteries regularly over time. Over a single weekend with a few appliances running, the batteries may be depleted and charged again numerous times.

3 Battery Types

 

 

 

 

 

 

 

3 types of conventional batteries

If this process is done over and over again without checking fluid levels, the batteries could become ‘cooked’: the lead plates inside are trying to provide power (or be recharged) without enough fluid to support the process. The lead plates heat up, chemical reactions occur inside and the battery melts or causes a fire.

Similarly, when storing for long periods of time (over the winter, as an example), batteries should be left in a fully charged state (so that the solution inside is an acidic solution, rather than water – which won’t freeze), with the cable(s) on the negative terminal left disconnected (this prevents any slow discharge from appliances connected directly to the batter over time).

For winter storage – these batteries are designed to be in sub-zero temperatures, provided that they are fully charged before storing for winter. With a full-charge, it is safe to leave batteries aboard, with the negative (black) cables disconnected from the battery. If the batteries are removed from the boat, they should be kept in a cool, dry place (basement or garage). When removing the battery cables, its good practice to clean the battery terminals and ring terminals with emery paper, and to apply petroleum jelly (Vaseline) to the battery terminals.

Maintenance is important – both as a safety concern, as well as to your pocketbook. Taking care of batteries in the short term will allow them to function properly, in the long term.

Related Articles
Ask the Experts
  • 05 December 2018
  • By Ethan

Ask Andrew: Boat ventilation

I passed by a person doing some shrink-wrap work recently, and as he installed a vent in the shrink-wrap he was completing, he muttered satisfactorily to himself ‘Air flow isn’t just for sail boats.

Destinations

  • Prev
We’re gliding through green-blue waters, colours so vivid and bright they hurt your eyes. We’re set ...
The Halifax waterfront has been attracting more and more large yachts in recent years. However, a ...
Ah Canadian simplicity at its finest; small town, big marina. Little Hilton Beach (population ...
Vancouver-based Big Blue Yacht Charters Worldwide owner Emma Murdoch explains that luxury crewed ...
In the 1920s, a small cove in Canoe Bay was used as a shipping point and safe-haven for rum runners ...
Here’s an update from Caroline Swann with some news for the adventurous types who may be heading to ...
The New Glasgow marina is located about six miles up the East River of Pictou in the heart of the ...
The British Virgins took a huge hit last fall from Irma. Boats were stranded on the shore by the ...
Located about half way between Shediac and the Miramichi on New Brunswick’s Acadian Coast, the town ...
Suddenly the once forsaken city of Hamilton, Ontario is booming for at least two good reasons.

Grenada: It was all so inviting...

The Large Island of Grenada

By Katherine Stone

Anytime a Canadian is asked to travel south in the beginning of our spring, which this year was far from inviting, is a dream worth living. The thought of a sailing adventure, tropical breezes, the smell of spices and the warmth of the sun was too much – we HAD to go! The first thing we did was to dig out the copy of Ann Vanderhoof’s book, The Spice Necklace, we had acquired several years ago and to re-read the seven chapters of their adventures in Grenada. Not only should this be your required reading, but the book is loaded with scrumptious Caribbean recipes that are a must-try.

Read more about Grenada...

 

 

Lifestyle

  • Prev
We are home for Christmas this year. Soon we will be heading back to Adamant 1 for another winter ...
This past October we drove to Telegraph Cove with friends and spent a day of wonder cruising the ...
We have kept our subscription to Canadian Yacht Onboard as we have traveled the South Pacific over ...
Stuart Walker a legend in competitive sailing passed away on November 12, 2018 in Annapolis. Stuart ...
“In Grenada, we had about 80 cruiser kids visit our boat...by dinghy of course! Sometimes you ...
Austin Edwards told students and parents at the Saanich School’s “Parents as Informed Partners” ...
As the sole arbiter of the Photo of the Week I, your editor, get to make the choice. This week, ...
Michele Stevens pointed us to this interesting project which recently came to fruition in Cape ...
Our Photos of the week this time come from BC where our friend Rob Stokes sent us a very nice ...
Our little treasure: Montague (Monte) taken at Pirate's Cove in the Gulf Islands. Monte is a ...

Boat Reviews

  • Prev
Quite simply, the styles of boats have changed. Where in past years a buyer might have been looking ...
At the boat shows, the Ranger Tugs’ classic tugboat lines always grab the crowds, with the wives ...
Sometimes a great idea requires an encore, and French yacht builder Jeanneau got that with the ...
Tactical Custom Boats announces the sale to a North American client of a custom Tactical 77’ – Fast ...
Bruce Elliott is an inventor. And when he sold the technology he developed to build utility poles ...
One often asks of a winning achievement or a fabulous design, could it have possibly been done ...
The latest new model from Cruisers Yachts is the Cantius 42 and this yacht made its debut in the ...
The Sabre 45 Salon Express is new for 2017, making its debut at the Fort Lauderdale International ...

Leader 9.0

Leader 9.0By Andy Adams

In the case of baking a cake, Betty Crocker and Julia Child both start off with the same eggs, sugar and flour, but the results can be very different. Naval architects, designers and engineers in the boat business also have many of the same ingredients, but the trick is to make the cake unique and desirable.

With a huge history of innovative design in boatbuilding, Jeanneau brings the sort of skill and artistry to their boats that can set them apart. Their new Leader 9.0 model is a case in point.

Read more about the Leader 9.0...

 

 

 

DIY & How to

  • Prev
Recently I suggested doing an off-season (winter) project with a potential client, and my ...
A recent conversation with a fellow contractor got me thinking: With all of the information out ...
As the cold approaches, shrink-wrapping is a hot topic, and I’ve heard more than a few debates at ...
Nothing stops a vacation faster than a problem with the fresh water system – be it leaks, smells, ...
Pyrotechnic distress flares have been around for decades, while electronic strobe distress flares ...
Most of us don’t give a second thought to our sacrificial anodes – those curious knobs of raw metal ...
In this time of boat show afterglow, many boaters are counting the days until launch. 

Ask Andrew – How to hire a boat repair contractor

hiring a contractorBy Andrew McDonald

A recent conversation with a fellow contractor got me thinking: With all of the information out there, including: Websites showing repairs, YouTube tutorials, Instagram pages and snapchat streams – let alone books, magazines, service manuals, and years of practical experience – how does a boat owner know which method(s) are ‘right’, who to trust, and who to hire to do the job? In short: How do you find and select a contractor?

Unfortunately, most people are forced to hire a contractor due to a circumstance where something has broken or failed, or the task...

Read more about hiring a contractor...

 

  

Marine Products

  • Prev
Looking for a great Christmas gift for the Offshore sailor on your list? This being a Marblehead to ...
Sail shape is long gone. They have stained, feels thin and you see broken threads everywhere. Your ...
Stripping the antifouling paint from the bottom of a boat is physically demanding and is one of the ...
The 2019 Ultimate Sailing Calendar highlights the drama and excitement of blue-water sailing, as ...
Weather nerds and boaters of all stripes will be absorbed by Bruce Kemp’s account of the monstrous ...
Canada Rope promises that its new Night Saver Rope will illuminate at night and act as a reference ...
Take a look as a 68-foot yacht docks itself in between two Volvo Ocean 65 sailing yachts at the ...
Industry Firsts Include Direct Injection and Integrated Electric Steering System
Verviers, Belgium, 18 May 2018 — Mercury Marine, the world leader in marine propulsion technology, ...
Again, we return to the beginning. We started this column with a look at marine navigation for ...