DIY Oil ChangeWinterizing your boat in the fall is important and may be a daunting task for some boat owners.  This is a DIY project that you CAN do on your own though.  Rob MacLeod, The Informed Boater, has put together a how to video with simple step-by-step instructions for completing an oil change, which is a good idea at the end of the season as part of the winterizing process.

Understanding how systems really work – and degrade over the winter – can help you prepare your boat for a trouble-free season. Here’s a guide from a pro…
Sometimes the most daunting thing about launching your boat in the spring is slogging through the checklist designed to "help" you do it. And no wonder: commissioning efforts for Canadian boaters run the gamut from paying a full-service yard to re-commission every system on board to putting away the one lonely space heater that's been wheezing away on the salon floor since Thanksgiving.

Under sail, these marvels of engineering deliver significantly less drag and greater speed than their traditional fixed-blade cousins. When I started sailing, the economical way to reduce propeller drag on a cruising sailboat was simply to install a two-blade prop. This worked fine – we had one on our 35’ sailboat for almost 30 years. Mind you, it didn't provide a lot of push in steep seas and headwinds, and we often used the mainsail to help punch us through a chop. Folding and Feathering Props

When it comes time to haul out this year, plan to give all your underwater gear a close inspection, measure and replace your anodes now and know you are ready for next season. In the fall, you can do this at your leisure. Understandably, we seem to be in a rush to launch again each spring and once the boat is in the water, replacing anodes is difficult to say the least!

It’s not just a matter of cost – there are simply lots of people who enjoy puttering around on their boats and doing their own mechanical work. There are many useful tasks that an owners can do to keep their own little ship “shipshape”, however there are some things where we say, don’t do it yourself! Generally, your fuel system is not a DIY item. For safety reasons alone, a boat's electrical wiring and grounding systems should always be handled by a qualified marine technician. But, there are other areas where home handyman knowledge can get you into trouble.

A few people winterize and store their own boat. Many of us pay the pros to do it. Spring commissioning is far more rewarding because you are preparing for a great summer with your boat. Winterizing is a tough chore because we usually keep boating until the weather turns nasty, plus you are struggling with that “down-feeling” that the boating season is over. That makes it doubly hard to dig in and do a great job of winterizing and protecting your boat for the winter.

So the boating season has finally arrived and since you have been a diligent owner, all your spring outfitting has been carefully attended to. Everything on that spring check list has been duly checked off and your guests are on their way. The coolers are filled with drinks and snacks and you’re looking forward to great day on the water. However, as experience has taught us, we are at our most vulnerable when our guard is down. Routine can lull us into a false sense of security. Now is the time to make sure you have a proper procedure for departure, one that can make the difference between fun on the water and a day of frustration, or worse.

New rules severely restrict where and how salt-water boaters can discharge sewage. Is your boat ready to comply? In May 2012 a significant environmental anniversary slipped by with little fanfare. It was the end of the promised five-year transition period before new sewage discharge regulations for small craft in salt waters, introduced in 2006-07, took full effect. From 2012 onwards all vessels in Canadian waters, fresh and salt, are covered by the same legislation regarding sewage discharge. Salt-water boaters have a bit more flexibility in pump-out options but the basic rules are now the same for fresh and salt water.

There is no end of discussion and debate about the fuel filtration needs of diesel engines. Myths and half-truths abound. So let’s set the record straight. Diesel engines are the most reliable of all internal combustion engines; they are robust and they need only two simple inputs, air and fuel. Properly maintained they will perform well for upwards of 15,000 hours before needing a re-build. By contrast, that is about three times the life of a well-maintained gasoline engine.

Even if you are on salt water and your boat can safely stay in the water year-round, are you using it regularly? Metal fittings are corroding all the time, the sun beats down on fibreglass and woodwork, and the rain and damp air all contribute to the slow but inexorable process of deterioration. When engines are used, oil and other lubricants are warmed up, spread around and parts are kept running freely. Air circulates through the interior when you are out and moving. Boats just like to be used more than they like being stored.

Destinations

  • Prev
Located about half way between Shediac and the Miramichi on New Brunswick’s Acadian Coast, the town ...
Suddenly the once forsaken city of Hamilton, Ontario is booming for at least two good reasons.
The Salty Dawg Sailing Association (SDSA) invites all sailors to join a cruising rally from the ...
Long popular with New England and St. John area boaters, Passamaquoddy Bay is too often overlooked ...
We did breakfast yesterday in the Greek port of Piraeus, just outside Athens:strong coffee, crisp ...
After much speculation Prince Harry finally popped the question to American actress and longtime ...
Last January we ran a short piece on the motor boat A Great Story which had been restored by the ...
The Moorings has just announced the launch of its newest Caribbean destination, Antigua. 
Toronto sailor and former RCYC coach/sailing instructor Ryan May is now a US coast guard captain ...
Just before the weekly party at Shirley HeightsSunsail staffer Chris Donahue conducts our chart ...

How to be as Polite as a Canadian at Gulf Island Marine Park Anchorages

Gulf Island Marine ParkStory and photos by Catherine Dook

One summer I sold ice cream and knick-knacks at Montague Harbour Marina. I was standing behind the counter one day, when the phone rang. “There’s a boat at anchor in the middle of the bay that’s been playing loud music for three hours,” complained an irate-sounding male voice. “Can you make them stop?”

“Um, no,” I replied. “The marina has no jurisdiction over the anchorage. Besides, my only weapon is a till.” The man hung up on me.

Now when you think about it, you can understand why the poor fellow was annoyed.

Read more about the Gulf Island Marine Park.....

 

 

Lifestyle

  • Prev
It’s Friday afternoon at the Newport Yacht Club in Stoney Creek, and that can only mean one thing - ...
We were all set with this week’s POTW when a real stunner came in as part of a story on the Blind ...
Have your say. Send an email to This email address is being protected from spambots. You need ...
When I was about ten years old I starting racing sailboats on Cape Cod and the sound of the wind ...
I took this photo in July 2017 from our boat Ginger which was anchored and stern tied in Mouat Bay ...
Were we nervous when we returned to Adamant 1 in November? The answer would be a hearty yes. The ...
Just to put it in historical time warp I was a World Sailing Vice President 1976-1994 and President ...
Great icicles! This is not what one expects from the tropical climes of BC. It’s a nice winter ...
Rossiter is a Canadian builder in Markdale, Ontario that builds a nice fleet of rowboats and small ...
Welcome to Photo of the Week 2018. If you are not familiar with this wonderful feature (What???!!!) ...
Canadian Yachting Digital April 2018

Boat Reviews

  • Prev
Commodore’s Boats is a full service shipyard with over 50 years of generational history and ...
Cruisers Yachts debuts the all-new 42 Cantius. The sporty, luxury cruiser will make its first ...
Once again, the designers at Jeanneau have outdone themselves with the innovative new Leader 10.5 ...
The introduction of X-Yachts’Xc range in 2008 has proven itself to be something of a game changer ...
Hull #1 ZINNIA, the all-new, twin outboard MJM 35z left Boston BoatWorks on July 5 for Newport and ...
Following a 10-year hiatus, Richmond, BC-based Crescent Custom Yachts is once again launching ...
According to the folks at Fraser Yacht Sales, you couldn't ask for more - the new Azimut Atlantis ...
During those cold, cold, sunless, dreary months of January and February, I want to remember the fun ...
The Rossiter 23 Classic Day Boatis both a logical extension of the Canadian-built Rossiter line and ...
It's rare for Canadian Yachting magazine to report on the same boat twice, but that is how ...

 

Cruisers Yachts Cantius 42

Cruisers Yachts Cantius 42By John Armstrong and Andy Adams 

The latest new model from Cruisers Yacht sis the Cantius 42 and this yacht made its debut in the fall of 2017, at the Fort Lauderdale International Boat Show. We had the pleasure of going all through this newest Cantius there and clearly, the Cruisers Yachts people continue to refine and expand on all the features that have made the Cantius line such a success.

The new 42 continues the Cantius family resemblance with handsome and distinctive lines including a big section of hull side glazing port and starboard that makes the full-beam mid-ship master stateroom feel very bright and open.

Read more about the Cruisers Yachts Cantius 42...

 

 

Marine Products

  • Prev
We have all had the experience of heading down below on a nice boat only to encounter an unpleasant ...
Last year when this column launched a good deal of time was spent understanding global satellite ...
This article was my first about 10 years ago, and it found it's way to an outdoor editor/writer ...
For a gloomy February we look not only at how an app that works within your phone can be of benefit ...
ZCare Marine, offers effective, eco-safe products to help keep your boat clean. They have products ...
Monaro Marine Ltd. of Richmond, BC, designs and builds its own unique brand of semi-custom 21' to ...
With Garmin it is now possible to use both devices without independently operating two devices with ...
When the Halifax Boat Show opens on February 8th there will be an excellent selection of pontoon ...
The 627 is the largest outboard in world. New cylinder heads and camshaft, an uprated ...
Sirius Signal held a product information session for interested parties prior to demonstrating ...