By Andy Adams

Teleflex Marine Introduces Optimus 360 by Seastar

Absolutely and without a doubt, the biggest advance in boating in recent memory has been the introduction of joystick docking. With these new systems, first pioneered in recreational boating by Volvo Penta in their IPS pod drive systems, docking a large boat in tight quarters, windy conditions, or in strong current was transformed from a task that would challenge the most experienced captain to something a child could do.

Children took to it almost immediately because joystick docking was so similar to their videogame controls and so intuitive to use; point the joystick in the direction you want the boat to go and it responds. Twist the joystick in the direction you want the boat to rotate and the boat responds.

With joystick docking, even older people with trick knees or other minor infirmities, can now continue enjoying their days out boating.

Behind the technology for joystick docking are great advances in computerized controls. The traditional throttle and gear levers attached to heavy mechanical cables have been replaced by drive-by-wire electronic controls. Typically, these come with failsafe and redundant systems to ensure your safety and owners are embracing the new electronic controls with enthusiasm.

But, what if you have an older boat with only mechanical controls? Is there any way to upgrade to a joystick docking scenario?

If your boat is equipped with twin outboards, there is now a joystick docking upgrade available and it works with the old mechanical shift engines.

This February, at the Miami International Boat Show, I had the opportunity to go out on an older centre console fishing boat rigged with older, two-stroke Mercury Optimax outboard motors with mechanical gear shift and throttle.

The boat had been rigged up by the tech guys at Teleflex Marine to demo what they call their new Optimus 360 joystick docking system. Before making you read any further, let me say that it was every bit as effective and every bit as impressive as any of the joystick pod drive boats that I’ve driven.

The feel of the system was excellent, shifts were quiet, smooth and positive and the test boat responded perfectly to every input at the joystick.

That was all the more impressive because the boat was a 32-foot SeaCraft that has a very deep vee bottom and a design that forces the engines to be mounted fairly close together, limiting leverage opportunities. Basically, this hull simply does not want to go sideways through the water.

But, no problem for the Optimus 360. Throughout the Miami show at the Sea Isle Marina, the Optimus 360 equipped SeaCraft and their other demonstration boat (which was a big Dusky centre console) spent the whole show going sideways up and down the channels!

The performance is simply stunning. It truly transformed both these boats but to be fair, it’s an $18,000 US upgrade. With that scale of investment, you won’t put this on just any boat. On the other hand, if you have a suitable subject boat that’s worthy of the investment and that has, or can be re-powered with outboards, the Optimus 360 deserves a closer look.

We know there are many sound and seaworthy older fibreglass hulls are out there, usually burdened with big heavy inboard engines, traditional shaft drive and rudder layouts, lackluster performance and heavy fuel consumption.

Today, all the outboard motor manufacturers have EPA-compliant, lightweight and powerful engine choices in the 150 to 300 horsepower range. New outboards could easily re-power a 28- to 36-foot flybridge or other desirable model and probably deliver significantly increased speed with reduced fuel consumption...plus joystick docking with the Optimus 360 system.

The components of the Optimus 360 system literally replace everything from the outboard engine forward to the steering wheel and control levers. Teleflex Marine has gained a great reputation for their SeaStar hydraulic steering systems available in regular and power-assist versions. The Optimus 360 system starts by replacing the old transom-mounted steering linkages with the Optimus electronic power steering system – one cylinder/pump combination for each engine and with no physical or mechanical connection between the engines.

Thus, each engine can turn independently of the other. That’s how they can make the boat go sideways, or spin.

Next, the system adds the new Optimus 360 joystick with its sophisticated performance features including what Teleflex Marine calls “guided feel”, a “boost mode” and “take command” mode. Guided feel helps the user to confidently control the boat both fore and aft, sideways, diagonal and even for rotational movements.

Boost mode increases the engine thrust for more docking power to overcome winds or strong currents. Take command mode is where a single touch button transfers control from the main to the joystick.

The steering wheel gets remounted on a new Optimus electronic helm with a wide range of adjustments. For example, you can adjust steering sensitivity and resistance for maximum comfort and most appropriate sensitivity while docking or at speed. You can change how quickly it responds in terms of the number of turns lock to lock and it can be speed sensitive, giving you fingertip low-speed control but increasing the effort required to better control a fast boat.

The system also includes the Optimus i6800 control head which gives full engine synchronization, allows slaved operation for one-lever control, has an integrated engine trim control and again, customizable feel.

The Optimus Smartcylinder is the actual steering mechanism that mounts to the engine. It’s designed to make installation simple.

Then comes the Optimus hydraulic steering pump that runs on-demand to reduce power consumption and has a convenient semi-automatic purge mode.

At the helm you mount the Optimus CANtrakDisplay that gives the captain visual information on the system status and is a simple interface for adjusting all the different controls like the engine turning ratio, joystick sensitivity and toe-in/toe-out of the engines.

Making the mechanical systems respond to the electronic controls is the Optimus pump control module. It uses a fault tolerant CAN Bus network design for ensuring system reliability, accommodating single-engine trolling operation and also isolates the cable connections from vibration.

The last component of the system is the Optimus i6800 control actuator. This reads the information from either the throttle levers or the joystick, integrates through the computerized systems and then provides independent shifting and throttle actuation for each engine, consistently delivering positive, but smooth shifting, even on the older Mercury Optimax engines on our demonstration boat.

Imagine somebody who can take their solid and much loved, but tired old flying bridge cruiser and re-power it with dramatically lighter, more economical and higher performance outboard engines mounted on transom brackets and controlled by the Optimus 360 system.

For an older twin outboard boat, you can add Optimus 360 for just $18,000 US. To re-power you older boat could wind up as a $60,000+ investment including new engines, but compared to a similar new boat (if there is a similar new boat on the market) that might be a great bargain. Suddenly, you get a new level of performance and convenience as well as years and years more boating.

You may feel that the math doesn’t work for you personally, but it certainly will for a lot of people and if nothing else, I bet all the OEM builders are looking at this as the ultimate upgrade on a new twin outboard boat. Well done, Teleflex Marine!


Photo Captions:
Photo 1 - Notice the patterns in the water and that the engines are angled in two different directions. The new Optimus 360 joystick docking system is moving the boat sideways into the fuel dock.
Photo 2 - Securely mounted in the dry, enclosed environment of the centre console underneath the helm, you see the two devices on the top left which are the Optimus i6800 control actuators to independently control gear shift and throttle, then below that the Optimus pump control module.
Photo 3 & 4 - At the helm, the handsome new Optimus 360 components include the electronic helm hub mounted under the steering wheel, the i6800 control head which are the throttle, trim, engine synch, throttle and gear levers and beside that, the joystick.
Photo 5 & 6 - In one photo the engines are angled the same way as you would normally expect, but in the other photo they’re angled differently. The different vectors and use of forward and reverse gears enables the boat to go sideways, spin and respond to the joystick.
Related Articles

Destinations

  • Prev
The Moorings has just announced the launch of its newest Caribbean destination, Antigua. 
Toronto sailor and former RCYC coach/sailing instructor Ryan May is now a US coast guard captain ...
Just before the weekly party at Shirley HeightsSunsail staffer Chris Donahue conducts our chart ...
Chartering in the Caribbean conjures up images of turquoise sea, palm fringed beaches and great ...
Since anyone who opens an independent bookstore is at least as brave as a small boat shop owner, I ...
You’re on your way east to the 1000 Islands or the Trent-Severn. By entering north of Prince ...
I have lived in Ontario my whole life but have only recently had the pleasure of visiting the City ...
My trip to the Northwest Passage started long before I boarded the flight to Kangerlussaq with ...
During the summer of 2016, my wife and I cruised through the North Channel in Lake Huron on our ...
It’s like we’ve waved a magic wand and disappeared into a picture perfect painting, our ...

The Middens of Galiano Island

By Catherine Dook

We motored our way into Montague Harbour along a twisted channel with our engine muffled by the leaning trees.

“This is peaceful,” I told my husband, John.

“Look,” I pointed to an eagle sitting on the top of a tree overlooking the channel entrance like a sentinel giving permission for us to pass. Dignified, unruffled, his impassioned gaze noted and then dismissed us, as uninteresting and perhaps unworthy. I was tired. We’d pulled up anchor at Portland Island that morning, and the grind of the diesel engine had worn me down.

Read More of the Middens of Galiano Island.....

 

 

 

 

Lifestyle

  • Prev
In the world of yachting, it is increasingly becoming the case that Canada is no longer the small ...
Ho-ho-ho. Our Photo of the week comes from Sunday’s Santa Parade. Clowning around was Paul ...
This Photo of the Week sequence from Chris Chahley and Kathy Coyle explains the whole boat thing. ...
The off season is suddenly upon us. Yikes! We need your photos more than ever to keep us thinking ...
One of our most enthusiastic contributors, Rob Dunbar sent us this photo from Halifax.   ...
Checking back into the US was quick and painless. We made the call to Customs but we needed to ...
Two-hundred-year-old homes are what ghost stories are made of, and Beaconsfield Yacht Club (BYC) ...
This time our photos come from Gimli where Katie Coleman Nicoll was on the scene. She’s an ...
Recently we celebrated our country’s 150th anniversary, and in true form thousands of ...
   We left off Part 1 at the year 1914, and will here pick it back up, running through ...

 

Boat Reviews

  • Prev
Commodore’s Boats is a full service shipyard with over 50 years of generational history and ...
Cruisers Yachts debuts the all-new 42 Cantius. The sporty, luxury cruiser will make its first ...
Once again, the designers at Jeanneau have outdone themselves with the innovative new Leader 10.5 ...
The introduction of X-Yachts’Xc range in 2008 has proven itself to be something of a game changer ...
Hull #1 ZINNIA, the all-new, twin outboard MJM 35z left Boston BoatWorks on July 5 for Newport and ...
Following a 10-year hiatus, Richmond, BC-based Crescent Custom Yachts is once again launching ...
According to the folks at Fraser Yacht Sales, you couldn't ask for more - the new Azimut Atlantis ...
During those cold, cold, sunless, dreary months of January and February, I want to remember the fun ...
The Rossiter 23 Classic Day Boatis both a logical extension of the Canadian-built Rossiter line and ...
It's rare for Canadian Yachting magazine to report on the same boat twice, but that is how ...

 

Cruisers Yachts Cantius 50

Cruisers Yachts Cantius 50By: John Armstrong and Andy Adams
Photos: Cruisers Yachts Inc.

Almost a decade ago, Cruisers Yachts Inc., launched an entire line of express cruisers called “Cantius” (named after company owner KC Stock’s grandfather) that began with the 48Cantius then came the 54, the 60 and now the Cantius 50. In the fall of 2017, we will be at the debut of the 42 Cantius at the Fort Lauderdale International boat show.

These designs have a strong family resemblance withhandsome and distinctive linesand with a design philosophy that you could say, pioneered the new version of the express cruiser. 

Read more of new Cruisers Yachts Cantius 50.....

 

 

Marine Products

  • Prev
I am fortunate to have the ability to work from just about anywhere. A cellular signal and a Wi-Fi ...
Out here on the West Coast with boats in the water year-round, there is one constant activity and ...
As I sit looking out my window at the snow that is slowly piling up it is easy to be downtrodden by ...
In the last edition of this column we took a close look at iRegatta and the advantages it can bring ...
With all the devastation in the eastern Caribbean a natural question to ask is ‘is our boat in that ...
During the heat of summer, many boat owners turn on their air conditioning units. Whether portable ...
A milestone has been reached. The new D13-1000 sees Volvo Penta move into the 1000hp marine leisure ...
  Still looking for the perfect slip for your boat? Look no further!    
Canadian Yachting traveled to Newport to review and sea trial the new MJM 35z.     ...
Erik Pawson Of Watertight Boatworks here in North Vancouver, BC, is really passionate about the ...