altWe’ve all seen it, or worse, had the experience ourselves; an older boat making a less than elegant landing due to sticky throttle cables, or stiff, balky steering. There are lots of older boats out there that get less use than they deserve due to old and uncooperative cables.

This is confirmed by the amount of discussion on various chat rooms concerning the problems associated with cables. Assuming your engine is in good working order, your steering and control cables are the next most important systems on your boat. Yet so often we see boats where these cables are poorly installed or corroded.

If you are having trouble with control or steering cables, the worst thing you can do is nothing. The problem will not resolve itself, but will only get worse and eliminate any chance of restoring the cable. A few simple precautions can make the difference between boating enjoyment and boating misery.

1) Start by checking the outer jackets on all cables for cracks. The problems come from various sources. In some older cables, UV rays can cause the outer jacket to crack allowing water to cause internal corrosion. Once this has happens, replacement is your only option.

2) Cables should be in a clean and sheltered area if possible. It sounds obvious, but be sure they are not being stepped on. This usually happens at the engine well.

3) Be sure there are no turns with a radius tighter than the manufacture minimum bend radius: 8” bend radius for solid wire core and 4” bend radius for TFXTREME.

4) Where the cables leave the control unit you should try to have at least a 1.5 foot straight run before any bends.

5) Also be sure there is enough slack at the motor end to allow for the engine turning.

6) All cables are internally lubricated, but the ends can become corroded. Make sure they are clean and free of corrosion

It is impossible to predict the life expectancy of steering or control cables due to the wide range of operating conditions in which they are used. These can vary from a few weekends a year in a northern freshwater lake, to year-round use in the warm, salty waters of south Florida. If your cables restrict or compromise your ability to control the boat, major manufacturers such a Teleflex Marine have connection kits that should allow retrofitting motors from the 1980s, 1970s and even older.

The compromise with cables has always been between having a tight core for precise response and a loose core which gives a smoother feel. However, in longer or more complicated runs the tight core becomes stiff and the loose core becomes sloppy. In reaction to these issues and to meet customer expectations, Teleflex Marine has come out with their TFXTREME technology. These cables utilize a patented splined core. The company claims these ridges allow a close fit with the inner liner but with less friction, resulting in very smooth and precise operation.

Steering Cables Steering You Wrong?

As with control cables, you shouldn’t wait until you have steering problems before doing some preventative maintenance on your boat’s steering cables. If the steering is stiff, this is a sign the system needs attention. Indeed, forcing the steering will just shorten the life of the cable. Steering cable maintenance is recommended at least twice a year and includes inspecting for signs of stiffness, binding, excessive free play and/or wear. These items cannot be repaired; if any components are not in good working order, replace them. Always replace steering cables that are stiff in operation or have damage to the plastic jacket. The interior of the cable is lubed for life however, particularly in salt water, corrosion can tighten the cable in the engine through tube.

Follow these steps to clean and lubricate the engine tilt tube or cable support tube and the steering cable telescopic output ram.

1) Remove the steering cable(s) telescoping ram from the tilt tube

2) Clean the tilt tube inside diameter thoroughly

3) Remove corrosion in the tilt tube with a wire brush and wipe until all loose material is removed.

4) Lubricate the tilt tube with a good water resistant marine grease.

5) Clean the steering cable telescopic ram with a brass wire brush and wipe clean.

6) Lubricate the sliding parts of the telescopic ram with high-quality, water resistant marine grease.

7) Reassemble, making sure all the correct fasteners are tight and there is no binding or excessive free play in the moving parts.

If you are re-powering an older boat, it is important be make sure the steering systems is properly matched to the engine. Teleflex, for example, sells both rotary and rack and pinion systems which are available with a no-feedback feature to eliminate the effect of engine torque. Your steering system is no place to compromise.

Today, replacement steering and control cables are simple and reliable. And, not that expensive, especially considering the cost of a docking disaster, or a sea tow due to a throttle problem out on the water. With some basic attention, there is no reason your old boat should not be a pleasure to operate.

www.teleflexmarine.com

By Glen Cairns

Destinations

  • Prev
NW Explorations, a Bellingham, Washington-based yacht charter, brokerage, and marine services ...
If you haven’t cruised the Rideau Canal before, you have missed a special treat and even if you ...
At the 2019 Vancouver International Boat Show I had the pleasure of meeting up with Allyson and ...
Following the harsh impact of Hurricanes Irma and Maria, The British Virgin Islands is making an ...
For the adventurous boater Bunsby Marine Provincial Park is a special place, situated due south of ...
There is good anchoring in Cowichan Bay and nearby, and salt water enough to make any boater happy. ...
We’re gliding through green-blue waters, colours so vivid and bright they hurt your eyes. We’re set ...
The Halifax waterfront has been attracting more and more large yachts in recent years. However, a ...
Ah Canadian simplicity at its finest; small town, big marina. Little Hilton Beach (population ...
Vancouver-based Big Blue Yacht Charters Worldwide owner Emma Murdoch explains that luxury crewed ...


Port of OrilliaTake your boat and a beautiful waterfront setting, pair that with a fantastic musical lineup of over 100 Canadian and international performers, spice it up with an awesome food truck alley, add in an artistically diverse artisan’s marketplace and finish it with a Folkplay area dedicated to children’s fun and you have the successful recipe for the Mariposa Folk Festival.

Each July this longstanding musical tradition kicks off the summer at Tudhope Park in Orillia on the picturesque shores of Lake Couchiching and you can get there by boat. This year’s festival runs July 5-7 and is celebrating 20 years back in the city where it all began 59 years ago.

Read more about the Mariposa.....

 

Lifestyle

  • Prev
John Booth, who passed away just a few weeks ago was one of the most amazingly gifted and ...
We left Vero Beach on Saturday morning with Alicia, a boat from Sweden, following close behind. The ...
At the end of last month, Canadian sailors gathered on the Palma Beach in Palma de Mallorca, Spain ...
In 2019, C-TOW celebrates its 35th anniversary of providing 24/7 “Peace of Mind Boating” for ...
West Vancouver Yacht Club reports that following an independent certification process the Georgia ...
It has been hot in the Abacos this winter. Whoever said this area was cool this time of year must ...
Unfortunately this is not a picture from a boat but was taken on the evening of February 27, 2019 ...
On March 1, Tom Ramshaw of Stoney Lake Yacht Club was honoured with the most prestigious National ...
Vero Beach, aka Velcro Beach, lived up to its reputation again. Our original plan was to be there ...
My husband and I were visiting the Bra d'Or Lake from Newfoundland in our 39 foot Sea Ray ...

Boat Reviews

  • Prev
ILCA is seeking new builders to complement its existing network of manufacturers, the International ...
Nelson Gilbert (1854-1921) began building canoes in Brockville in the 1890s, a time when the sport ...
I have heard a lot of talk lately about trends in yacht clubs where senior membership is getting ...
To get you in the mood for cruising the Boat Show then launching in spring, here’s a boat that ...
Quite simply, the styles of boats have changed. Where in past years a buyer might have been looking ...
At the boat shows, the Ranger Tugs’ classic tugboat lines always grab the crowds, with the wives ...
Sometimes a great idea requires an encore, and French yacht builder Jeanneau got that with the ...
Tactical Custom Boats announces the sale to a North American client of a custom Tactical 77’ – Fast ...
Bruce Elliott is an inventor. And when he sold the technology he developed to build utility poles ...
One often asks of a winning achievement or a fabulous design, could it have possibly been done ...

Grand Banks 60 SkyloungeThe Canadian market has always been a tough nut for yacht designers to figure out. Summer days get really hot; other days are downright cold. There is always the chance things could change in the blink of an eye and let’s be honest, who among us hasn’t stepped off the boat wearing shorts, flip flops and a warm jacket? Canadian yachting has always been a world of contradictions, which is why designing cruising yachts for this market has never been easy. It’s not like Florida or the Med, where weather is dependable throughout the year.

 

 

Read more about the Grand Banks 60 Skylounge............

 

ILCA DinghyAustin, Texas, USA (25 April 2019) – In the wake of last month’s termination of its contract with its European builder, the International Laser Class Association (ILCA) announced today that, from 25 April 2019, all new, class-approved boats will be sold and raced under the “ILCA Dinghy” name. This change will have no impact on existing ILCA-authorized boats and equipment, which will be able to race alongside ILCA Dinghies in all class sanctioned events.


“It’s a big change for a racing class that hasn’t seen anything like this in our almost 50- year history,” said Class President Tracy Usher.

Read More about the ILCA Dinghy............

Marine Products

  • Prev
Finding a car brand that you enjoy while it does what you need can be tough, as they can be ...
Yikes! No boat refrigeration? You’ve Got to be Kidding me!! But then again, true campers don’t use ...
The Walker Bay Venture 14 claims to be the world’s first luxury Explorer Sport Tender. It is ...
Mercury Marine is pleased to announce the launch of the new MerCruiser V8 6.2L 370hp Jet Ready ...
My history with the Cayenne goes back many years, as I was at the launch of the original vehicle ...
Last month, Mercury Marine has announced the launch of the 400hp Verado outboard engine, the ...
Featuring advanced, intuitive 3D controls, Zipwake Dynamic Trim Control Systems deliver a more ...
Gina de Vere approached me at the Canadian Yachting booth at this year’s Vancouver International ...
A revolutionary “assisted docking” system that provides a glimpse into the future of boating ...
After developing the Figaro Beneteau 3, the first production foiling sailing yacht, Groupe Beneteau ...