So, I have to open with a joke. There are two kinds of people in the world: those who divide all the other people in the world into two kinds of people, and those who don’t.

For the purposes of this article, I do!

To be more specific, I divide boaters into two kinds of people: those who want to play in the engine room and those who don’t. Whether your boat is power or sail, you are almost certain to have an engine and every engine needs maintenance and occasional repair.

Boat engines lead difficult lives. They sit there unused, cold and damp in the engine room for days, weeks, sometimes months and then we expect them to fire right up and – within a few minutes – be able to run at maximum RPM.

They’d better be able to run at maximum RPM. If they can’t take full throttle, you may not get the boat to plane off. Also, if they can’t make it up to maximum RPM, you know that something’s wrong.

Perhaps the engine isn’t getting enough air. Something may be blocking the ventilation that could heat things up and even cause a fire. An engine that won’t reach maximum RPM may have a fuel delivery problem, ignition or timing problems; another possibility is that the transmission or drive system has a problem.

A salty old master mechanic once told me that, at least for a short blast once the engine is warmed up, you should take it to maximum RPM every time you use the boat. Whether you agree or not, it’s something to think about.

If you’re the kind of person who doesn’t want to go into the engine room, that advice is particularly valuable. Instead of getting your hands dirty, your observations of how your boat is running is the best way to tell if it needs service (outside of regular maintenance intervals, of course).

If you are the other kind of person who does like to venture into the engine room, just looking around and checking for problems is a great way of avoiding problems when you’re out on the water.

You might see a coating of oil, a dusting of rubber fragments on engine parts or on the floor and you might smell oil or worse, fuel in the bilge. These are all obvious signs of trouble. Get the mechanic to check it out before you head out.

The well-rigged engine room helps you to be proactive about inspecting your engines and drives.

We have found that many new boat builders have rigged their engine rooms with clearly visible seawater strainers, brightly marked oil dipsticks, visible indicators on trim pumps for the fluid level, sight glasses for coolant levels and large glass bowls on oil filtration systems so that one can easily see if water or other contaminants are fouling the oil.

The best engine room is the one that’s easy to get to for maintenance.

However, with all the boat reviews we do at Canadian Yachting, we often think that engine room access takes a back seat to design and layout. It sometimes seems that the mechanical systems are dictated by stylists, not the engineers or the technicians who will be doing the maintenance and repair work later.

Our biggest concern is for our readers' safety should they experience mechanical problems in rough water when the engine is hot. Crawling into the engine room when the boat is rocking with winds and waves risks injury. So, let’s avoid needing to go there.

Among the top quality, popularly priced boats, we have long felt that Cruisers Yachts does a particularly good job with its engine room rigging. So, when we were at the facilities in Oconto, Wisconsin, we interviewed Jon Viestenz and Todd Trepanier while on board the new Cantius 41. Todd guided us to the finer points of that engine room and we made a short video about it. You can see that on the Canadian Yachting website at www.canadianyachting.ca.

If you are doing some new boat shopping at the shows this winter, or working with a broker to find you your dream boat, these ideas and suggestions should help you avoid an engine room nightmare.

First, look for a boat that was built to American Boat and Yacht (ABYC) standards. These are largely reflected in Transport Canada construction standards and National Marine Manufacturers Association (NMMA) standards. Ask your dealer for information.

Then, make sure battery and electrical connections and switches are accessible and clearly marked.

Next, consider how you can physically get into the engine room if a breakdown were to occur in high waves. Is there a risk of hitting your head, getting burned on a hot engine part, falling down a ladder, or losing your balance?

Is there access all around the engine(s)? You want to see all sides when checking for an oil leak. Are oil dipsticks and filter sight glasses easily checked? Can you physically reach all critical systems like hydraulic steering hoses and connections, fuel lines, and important electrical connections without crawling over a hot engine?

Could you clear a raw water strainer or shut a through hull fitting? Is there strong enough light in there to even see, let alone fix a problem?

Taking a powerful flashlight is good too; you can never have too much light in the engine room.

Hopefully, the builder has clearly marked every line and wire so you know what each one is for. If they haven't done that, work with your dealer’s mechanic to put a big label on all important parts.

Take the owner’s manual with you, or print one off (if it has not been supplied) and keep that copy handy too.

If you do have to go below in an emergency, station another person nearby and talk your way through it. Finally, don’t be afraid to call for help if you need it!

By Andy Adams

Destinations

  • Prev
Toronto sailor and former RCYC coach/sailing instructor Ryan May is now a US coast guard captain ...
Just before the weekly party at Shirley HeightsSunsail staffer Chris Donahue conducts our chart ...
Chartering in the Caribbean conjures up images of turquoise sea, palm fringed beaches and great ...
Since anyone who opens an independent bookstore is at least as brave as a small boat shop owner, I ...
You’re on your way east to the 1000 Islands or the Trent-Severn. By entering north of Prince ...
I have lived in Ontario my whole life but have only recently had the pleasure of visiting the City ...
My trip to the Northwest Passage started long before I boarded the flight to Kangerlussaq with ...
During the summer of 2016, my wife and I cruised through the North Channel in Lake Huron on our ...
It’s like we’ve waved a magic wand and disappeared into a picture perfect painting, our ...
The Schooner Cove Yacht Club is situated between Nanaimo and Parksville, on the east coast of ...

Cowichan Bay to Genoa Bay – Almost the Gulf Islands

Cowichan Bay to Genoa Bay – Almost the Gulf Islands

 By Catherine Dook

“So you’re going offshore to Genoa Bay,” said an old salt at coffee that morning. Genoa Bay was 15 minutes away from our homeport of Cowichan Bay and hardly counted as offshore, but it was our first destination that fall. The fog had socked us in all that morning, so John and I drank coffee and gossiped with the neighbours while waiting for the weather to lift. We’d provisioned with cans of chilli, a sack of apples, and tanks full of water. We’d tested the engine and the anchor winch. We were ready.

Read More of Cowichan Bay to Genoa Bay.....

 

 

 

Lifestyle

  • Prev
One of our most enthusiastic contributors, Rob Dunbar sent us this photo from Halifax.   ...
Checking back into the US was quick and painless. We made the call to Customs but we needed to ...
Two-hundred-year-old homes are what ghost stories are made of, and Beaconsfield Yacht Club (BYC) ...
This time our photos come from Gimli where Katie Coleman Nicoll was on the scene. She’s an ...
Recently we celebrated our country’s 150th anniversary, and in true form thousands of ...
   We left off Part 1 at the year 1914, and will here pick it back up, running through ...
This week’s POTW comes from across the pond. Who knew we had a European audience   ...
Here is our boat anchored at Hockey Stick Bay. We live in a beautiful country.     ...
Michelle Jacques of Cambridge ON share this memory of her adorable pooch. “This is Frodo. ...
  Our 150 year history began in 1867, but Canada was no stranger to watercraft prior to our ...

 By: Katherine Stone

Do you know how many boaters you run into while standing in the lift lines of Blue Mountain and the surrounding private ski clubs? Quite a few! Start some conversations on the ski lifts and you might be surprised how many avid boaters you can meet.

Many who boat say that winter sports are just there to pass the time until the ice clears and you can get your boat launched and start boating again. As a ski instructor, you tend to meet even more interesting boaters… Read more about the Reef Boat Club ....

 

 

Boat Reviews

  • Prev
Commodore’s Boats is a full service shipyard with over 50 years of generational history and ...
Cruisers Yachts debuts the all-new 42 Cantius. The sporty, luxury cruiser will make its first ...
Once again, the designers at Jeanneau have outdone themselves with the innovative new Leader 10.5 ...
The introduction of X-Yachts’Xc range in 2008 has proven itself to be something of a game changer ...
Hull #1 ZINNIA, the all-new, twin outboard MJM 35z left Boston BoatWorks on July 5 for Newport and ...
Following a 10-year hiatus, Richmond, BC-based Crescent Custom Yachts is once again launching ...
According to the folks at Fraser Yacht Sales, you couldn't ask for more - the new Azimut Atlantis ...
During those cold, cold, sunless, dreary months of January and February, I want to remember the fun ...
The Rossiter 23 Classic Day Boatis both a logical extension of the Canadian-built Rossiter line and ...
It's rare for Canadian Yachting magazine to report on the same boat twice, but that is how ...

 

A Trip To Iconic Italian Yachtbuilder Riva And Lake Como

Riva And Lake ComoStory And Photos By Iain Macmillan

Eyes turn and conversations on shore pause as one boat in particular approaches the Grand Hotel Serbelloni’s jetty that extends out into the sparkling blue waters of Lake Como off Bellagio, northern Italy. It’s not because the Clooneys, George Lucas or Richard Branson are on board, not this time anyway, the attention is on the boat itself. The world’s most valuable, most magnificent mahogany launch, a classic 1960s Riva Aquarama, is paired appropriately with Como’s most prestigious hotel, its Michelin star dining room and suites that have housed royalty; a perfect mix of pleasure, luxury and a distinguished history.

Read more about Riva and Lake Como....

 

 

Marine Products

  • Prev
With all the devastation in the eastern Caribbean a natural question to ask is ‘is our boat in that ...
During the heat of summer, many boat owners turn on their air conditioning units. Whether portable ...
A milestone has been reached. The new D13-1000 sees Volvo Penta move into the 1000hp marine leisure ...
  Still looking for the perfect slip for your boat? Look no further!    
Canadian Yachting traveled to Newport to review and sea trial the new MJM 35z.     ...
Erik Pawson Of Watertight Boatworks here in North Vancouver, BC, is really passionate about the ...
Hydro Clean Hull Wash is Canada's first automatic, mechanical hull wash system and the company has ...
For 2017 there were a total of 31 events planned and 2 were cancelled for a total of 29 events. All ...
When Terry Conrad, of Conrad Marine, offered me ride in a brand-new Sea Fox 288 Commander that he ...
EMCS Industries Ltd. has a unique antifouling system that’s quite clever and incredibly ...

By Owen Hurst

Since the initial article of this series we have looked at the iPad and its use as a marine navigation instrument. We have discussed its functionality, available apps, relevant hardware and compared it to traditional charplotters. This focus on iPad led one of our readers to an interesting question that we have yet to address.

Question: Why has the focus been solely on the use of iPads for marine navigation rather than Android devices?

Read More Going iPad or Android.....