Ethanol250“I would estimate that 90% of our service calls this summer related to fuel system problems of one kind or another,” I was told by Shawn Ireland at Lakeline Lodge and Marina, a Yamaha dealer and the only service facility on Charleston Lake in Athens, Ontario.

I was talking to Shawn because my own little Whaler was disabled twice during the summer and, in both cases, a sticking needle valve in the 20 horsepower outboard had to be freed up. Then, the engine ran perfectly. The problems occurred after the boat had not been run in a week or longer. Probably, old gum or varnish was being dislodged by the solvent effects of the ethanol and dispersants also used in the fuel.

As we all haul our boats out and store them for the long winter, it’s certainly worthwhile to revisit the ethanol issue because things seem to be getting worse, not better.

We went to several of the top tech experts on this matter and we will share with you their best recommendations.

But first, we need to better understand the problem.

Tetraethyl lead was long used as an octane booster in gasoline but has been banned due to environmental problems. To replace that lost octane boost, oxygenated fuels were introduced and they usually contain either ethyl alcohol (ethanol) or methyltertiary-butyl-ether (MTBE). MTBE, too, raised environmental concerns so now ethanol has become the commonplace solution.

Remember: Gasoline is formulated for your car or truck – NOT for marine use.

Your vehicle burns a tank of fuel in a short period of time and vehicles have long been equipped with closed fuel systems that minimize evaporation and deliver fuel under pressure to fuel injectors. Fuel dispersants like detergent are added to help keep fuel injector nozzles clean. Little air enters the system.

Your boat is completely opposite; marine fuel systems are vented to the air because fuel must be drawn into the engine under a vacuum. It’s a safety feature. Should a hose come loose or the fuel system develop a leak, gasoline stops running. Otherwise, you could find yourself at the helm of a 36-foot hibatchi!

We can divide the ethanol fuel problems into two general areas: operating problems and tank problems.

The operating problems seem to come from gum, varnish and debris from fuel system hoses and parts that the ethanol has attacked. The most dramatic operating problem occurs when a blob of water and ethanol gets sucked into the carburetor, causing the engine to stop or stall. These blobs are a result of “phase separation”.

Since ethanol and water readily dissolve in each other, when ethanol is used as an additive in gasoline, water will actually dissolve in the blended fuel to a much greater extent than in conventional gasoline. When the water reaches the maximum amount that the gasoline blend can dissolve, any additional water will separate from the gasoline.

The amount of water required (in percent of the total volume) for this phase separation to take place varies with temperature, but as an example, at 60 degrees F, water can be absorbed by a blend of 90% gasoline and 10% ethanol up to a content of 0.5 volume percent before it will phase separate. This means that approximately 3.8 teaspoons of water can be dissolved per gallon of the fuel before the water will begin to phase separate.

We realize that many Canadian Yachting readers have diesel engines in your sail and powerboats but the ethanol problem affects you if you have a dinghy or tender with a small outboard. Actually, those engines are more exposed to the ethanol issue because most dinghies are stored for long periods of time between uses.

Things get worse again if that little engine is a key part of your safety gear.

Water can enter ethanol-enhanced gasoline either directly (like rain water running off and splashing into a fuel vent – think of vented cap on a portable 5-gallon fuel tank) or through moisture being absorbed from the air, especially during daily temperature changes when condensation occurs.

To get more than 3.8 teaspoons into the bottom gallon of fuel in your outboard’s portable tank might not take many cool fall nights.

Water as a separate phase, can have a major effect on two-stroke outboard engines because when the ethanol bonds with the water and drops out of the gasoline, the effective octane rating is decreased. Also, in the case of two-stroke engines, this water-ethanol phase will compete with the blended oil for bonding to the metal engine parts. Therefore, the engine will not have enough lubrication and engine damage may result.

In the case of four-stroke gasoline engines, the water-ethanol phase may combust in the engine. This combustion can be damaging to the engine because the water ethanol phase creates a leaner combustion mixture (i.e., air to fuel ratio is higher than ideal). Leaner mixtures tend to combust at higher temperatures and can damage engines, particularly those without sensors to calibrate air to fuel ratios.

So What Do You Do? Here are Some Recommendations form the Experts

•            Check with your marina or gasoline retailer. Some retailers, like Ontario area Shell stations sell Shell V-Power Premium and the pump is clearly marked “Contains No Ethanol”. If you can be sure your fuel has no ethanol, you have no problem.

•            If your boat has a fiberglass fuel tank; ethanol is known to chemically react with many fibreglass fuel tanks. They can deteriorate and potentially fail causing both serious engine damage and potential fuel leaks. Unless your boat's manufacturer can confirm that your fibreglass tank was built to withstand ethanol, over the winter, replace the tank with a non-reactive material such as aluminum.

•            Always use fuel stabilizer. For any stored gasoline, it's important to add a stabilizer. Also, several engine manufacturers now recommend adding a “maintenance” level of stabilizer in every tank. However, stabilizers do not prevent phase separation. Once it occurs, additives and water separators can't help. The only remedy is to have the gas and ethanol/water professionally removed from the tank.

•            Before storage, run your boat for a time on stabilized fuel to best ensure that fresh, stable fuel is all that remains in the system over the winter.

•            For boats with built-in fuel tanks, if possible, professionally drain and clean the tanks completely. We realize this is highly impractical though, so alternatively, add stabilizer and then almost fill the tank, leaving it with just a little room for expansion. A tank that is almost full limits the flow of air into and out of the vent, which reduces the chance of fluctuating temperatures adding condensation (water) to the fuel and thereby reducing chances of phase separation.

•            If you have (or can change to) portable 5-gallon tanks, any unmixed gas (without 2-cycle oil) remaining may be carefully poured into your automobile gas tank and used. If you must store gas over the winter, keep the tank out of the sun and in a well-ventilated area away from ignition sources, keeping in mind that gasoline fumes are heavier than air.

•            For all marine gasoline tanks, never try to plug up a fuel tank vent to prevent moist air from entering a tank. Without room to expand, the additional pressure could rupture fuel system components. Don’t block the vent with shrink wrap!

Boat Reviews

  • Prev
New at the end of 2019, the 58 Salon Express design features large windows to flood the living ...
No wonder this is one of Regal’s best-selling boats; the Regal 33 Express offers amazing ...
The newest member of Beneteau’s Gran Turismo line is the GT 36 and this yacht brings the style and ...
With a philosophy of quality and 'doing things right Ranger Tugs launches the all new R-25 at the ...
The new Beneteau Swift Trawler 41 renews the spirit of the practical seaworthy cruiser. The ...
The Canadian Yachting test crew last week had the opportunity to run the Bavaria S36 HT at St ...

CY Virtual Video Boat Tours

Virtual Boat ToursWe all love boats and nothing can break us up! So, what better way to spend our time than looking at interesting boats and going aboard in a virtual ride or tour. We have asked our friends at various dealers and manufacturers to help us assemble a one-stop online resource to experience some of the most interesting boats on the market today. Where the CY Team has done a review, we connect you to that expert viewpoint. Our Virtual Show will continue to grow so visit frequently and check it out. If you can’t go boating, you can almost experience the thrill via your screen. Not quite the same, but we hope you enjoy our fine tour collection.

 

Read more about the CY Virtual Boat Tours....................

 

Beneteau Oceanis 30.1As boat builders clamber to create ever-bigger platforms for ever-more generous budgets, the entry-level cruiser has become an elusive animal. Sure, if you want to daysail, there are plenty of small open boats from which to choose, but if you want a freshly built pocket cruiser, you’re in for a long search. Enter French builder Groupe Beneteau, which identified this gap in the market and set about creating the Oceanis 30.1, an adorable little cruiser that resembles her larger siblings in all but length and price. With all she offers, it wouldn’t be a stretch to call her a mini yacht.

Read More about the Beneteau Oceanis 30.1..................

Destinations

  • Prev
On May 19, the New York State Canal Corporation today announced an updated opening schedule for the ...
If you have four hours to enjoy a fine tour of one of Canada’s most interesting waterways (let’s ...
Boom & Batten Restaurant is suspended over the water adjacent to the Songhees Walkway and ...
Provincial Boat Havens are those special places to drop anchor in British Columbia’s West Coast and ...
NW Explorations, a Bellingham, Washington-based yacht charter, brokerage, and marine services ...

DolphinsBy the Canadian Yachting Editors


Canadians are blessed in many ways and especially when it comes to boating. We enjoy some the world’s most beautiful cruising waters and many places are as sheltered as they are scenic.

British Columbia and the Pacific North West plainly have the most breath-taking scenery with the combination of the majestic ocean views and the snow-capped mountains in the distance. It’s like no place on earth when you have a Killer Whale breach beside your little fishing boat.

Read more about Canadian Cruising...........

 

Lifestyle

  • Prev
The Council of British Columbia Yacht Clubs with over 50 yacht club members has become the voice of ...
Classic boat restoration expert and wooden boat builder Stan Hunter recently sent us this great ...
In Mid June, a floatplane plunged into Constance Bay on the Ottawa River after two planes collide ...
Winter is a fun time for sailmakers in Canada. We grind through mountains of repairs and have an ...
The seasoned sailor mapped out an ambitious course around the world — aboard his 28-foot ...
Clean wake: A concept amongst cruising sailors that stresses the impact that individual behaviour ...
This line-up of Beneteaus can to us from our friends at RCR Yachts in NY State where they are ...
As another harsh Victoria winter came to a close, the deck repair and refinishing continued with ...
The Peterborough Canoe Company was formed in 1892 and began production the following year after ...
On one of the sunny days we had recently, Kyle MacTaggart in Honey Harbour ON fired up the Merc to ...

Cobourg Yacht Club - 2015 Sailing instructorsKatherine Stone

Like many other harbours on Lake Ontario, Cobourg has seen its fair share of changes. Screams used to be heard from kids piled into a toboggan on wheels that went hurtling down a wooden slide into the harbour. Above it all was the bustling din from the waterfront of ship’s whistles, train engines, foghorns and thundering coal cars. It is now a rather serene place for the locals and visitors to enjoy various watercraft. Fortunately, the beautiful beach that lines the waterfront is still a star attraction for the town.

Located 95 kilometres east of Toronto and 62 kilometres east of Oshawa on the north edge of Lake Ontario, United Empire Loyalists first starting arriving in the area as early as the 1780s. The first settlement in 1798 was called Buckville, later renamed Amherst, then called Hamilton (after the township) and also nicknamed Hardscrabble. It wasn’t until 1819 that they finally settled on the name of Cobourg, which was incorporated as a town in 1837. In the late 1820s large schooners with passengers and cargo had to anchor well off shore, as there was only a landing wharf. A group of Toronto businessmen formed the Cobourg Harbour Company which built the wooden Eastern Pier from tolls charged for the use of the harbour.

Read more: Cobourg Yacht Club...

Marine Products

  • Prev
Wet decking can compromise passenger safety on boats, particularly when boarding or disembarking. ...
Anyone who has repeatedly used a rag to clean gelcoat, paint and delicate surfaces has seen the ...
The new Mercury Racing 300hp Five‑Blade CNC Cleaver propellers are designed expressly to maximize ...
Beneteau may have outdone itself with introduction of its new Gran Turismo 36, manufactured in ...
Yanmar Power Technology has announced the development of a hydrogen fuel cell system for maritime ...
Kevin Monahan is a retired Canadian Coast Guard officer with more than 20 years of experience ...
The new 2020 PORTS Georgian Bay, North Channel & Lake Huron Guide is available for purchase at ...
Professional boatbuilders don't want to have to redo a job any more than a DIYer. Many choose Life ...
Since its introduction last year, the JBL by Harman Marine BassPro 10" Powered Subwoofer (JBLMBP10) ...
After decades of perusing charts and guidebooks as part of planning a cruise, it was a totally ...